There are many ways to consume cannabis products these days. One of the most popular is dabbing. The term "Dabbing" comes from the term for a hit of cannabis concentrates, known as a "Dab". These products are testing typically between 70%-99% Total Active Cannabinoids so vaping this stuff isn't for the faint of heart because quite literally, "A dab will do ya". Popular Temps For Dabbing: You can use either a temperature gun or a Dab Rite to determine the temperature of your dab if you are using a dab rig or traditional bong. -For a very terpy flavor and a light vapor, dab at a lower temp. Somewhere between 300F-400F. -For a slightly less terpy flavor and a good amount of vapor, dab at a mid-range temp. Somewhere between 400F-500F -For a less terpy flavor but a lot of vapor, dab at a higher temp. Somewhere between 500F-700F Popular Methods For Dabbing: -Dab Rigs -Traditional Bong -Electronic Vaporizes (PuffCo, Carta) -Nectar Collector -Placing It On Top Of A Bowl Of Flower -Rolling It Inside Of A Joint or Blunt Dabbing Process For Electronic Devices: Step 1- Use a dab tool to scrape up and prepare your dab (Typically recommend somewhere between .025g to .1g.) Step 2- If using an electronic dab rig, place your dab into the bowl and commence the heating process. Step 3- Cap the bowl and wait for desired heat setting to be reached. Step 4- Pull on mouthpiece slowly and inhale your desired amount of vapor. Step 5- Use a q-tip to clean the bowl after you are done Dabbing Process For Dab Rigs/Traditional Bongs: Step 1- Use a dab tool to scrape up and prepare your dab (Typically recommend somewhere between .025g to .1g.) Step 2- Use a torch to heat up nail, banger, trough or terp slurper until it is red hot. Step 3- Depending on the nail (banger, trough or terp slurper) age and quality, let it cool down for anywhere between 60 seconds to 120 seconds. It should feel warm when hovering your hand over the nail. Should not feel HOT. Step 4- Once cooled down enough, drop your dab into the nail and place a cap on top of it to slightly restrict airflow. Step 5- Slowly pull on mouthpiece and inhale your desired amount of vapor. Step 6- Use a q-tip to clean the bowl after you are done Dabbing Process For Nectar Collector: Step 1- Heat up stainless steel tip of the Nectar Collector Step 2- Point at and touch the concentrate with the stainless steel tip of the Nectar Collector. Step 3- Slowly pull through the mouthpiece and inhale desired amount of vapor. Dabbing Process For Placing A Dab On A Bowl Of Flower: Step 1- Pack a bowl of some dank flower in your pipe or bong. Step 2- Separate a dab of concentrate and place it on top of the bowl of flower. Step 3- Use a lighter to melt down the oil and eventually begin to burn the flower. This causes the oil vapor to mix with the flower smoke which creates a wonderful mix of both worlds. Step 4- Dump your spent bowl out and reset. Dabbing Process For Rolling Dab Inside Of A Joint Or Blunt (Known As A Donut Hole): Step 1- Roll up a blunt or a joint with some dank flower but seal it up yet. Step 2- Take concentrate and roll it into a slug shape if its rollable. If not rollable, you'll be dropping it directly into the flower from the concentrate jar. Step 3- Once concentrate is placed into the roll, seal it up and get ready for lift off. Step 4- Light up your roll and enjoy! Step 5- Don't litter and be sure to recycle that roach!